HB350 hardness greater than titanium machining particularly difficult

HB350 hardness greater than titanium machining particularly difficult, less than HB300 is prone to stick a knife phenomenon, but also difficult to cut. However, only one aspect of the hardness of titanium machining difficult, the key is the combined effect of its machinability of chemical, physical and mechanical properties of titanium itself between. Cutting Titanium has the following characteristics:
(1) deformation coefficient is small: This is a significant feature of titanium machining, deformation coefficient is less than or close to one. Chip away the knife sliding friction surface greatly increases the previous accelerated tool wear.
(2) high cutting temperatures: As low thermal conductivity of titanium alloy (equivalent to only 1/5 ~ 1/7 45 steel), the contact length of the chip and the rake is very short, the heat generated when cutting difficult to pass out, concentrated in a smaller range of the cutting area and near the cutting edge, high cutting temperatures. Under the same cutting conditions, the cutting temperature higher than 45 steel cutting more than doubled.